We use cookies to give you the best experience. If you do nothing, we'll assume that's OK.

Manual for applying nano impregnation on natural wood

Treatment procedure:

  • Before applying the treatment, the surface must be perfectly clean and rid of grease, for the protective layer to bind directly to the surface of material. Do not take this step lightly, since it directly influences the achieved effect and longevity of protection! It could easily happen that you would apply the NANO protection on a non-absorbent surface treatment of the wood or on dust, sand or other dirt on the surface, instead of applying it directly on absorbent wooden surface.
  • We recommend using pressure cleaning with water only. Afterwards, leave the surface to dry completely. This will maximize the ability of the protection to bind directly to the base material. The binding of the nanoprotection directly to surface is the most important part in every application.
  • The application of protection as well as the following binding of the nanoprotection with the treated surface must take place for 24 hours within temperatures of 3°C-30°C. If the protection is being applied in exterior, it must not rain within the 24 hours.
  • After thorough cleaning and drying, apply the protective medium on non-treated surface of wood (or natural wood) in a manner in which it sufficiently absorbs the nanoprotection.
  • Apply the impregnation using a sprayer from approx. 15-20 cm from the treated surface.
  • The consumption is affected by the absorbency of the base material and the informative consumption value is listed on every product.
  • After treatment, the water resistance will appear after complete drying of the treatment. The resistance to abrasion and chemical resistance will appear after 24 hours.
  • We recommend testing the effect after 24 hours.The aftercare is possible with ordinary detergents.
  • In case of any further questions, please take a look at frequently asked questions or do not hesitate to contact us!